The Thermaltake M-Pro fitting kit is the complete liquid-cooling fitment package. Inside you’ll find six of our exclusive M-Pro fittings which make LCS installation easier and more stable. You’ll also get two right angle compression fittings to help you complete you brand new loop.

Thermaltake Pacific M-Pro G1/4 PETG 12mm OD Compression - Chrome

The M-Pro is our latest and greatest LCS design, making custom loops accessible for more users. Featuring chrome plating, the Pacific M-Pro G1/4 PETG 12mm OD Compression comes with special triple O-ring leak-free design and patented structure for ultimate loop management.

Thermaltake Pacific G1/4 PETG Tube 90-Degree Dual Compression 12mm OD – Chrome

The Thermaltake Pacific PETG Fittings provides a complete solution for enthusiast and custom PC builders to meet the needs of setting up a complete water cooling system. With G1/4” durable copper fittings, finished in chrome coatings, these fittings are the perfect complement to the new M-Pro range.

Tt LCS Certified

Tt LCS Certified is a Thermaltake exclusive certification applied to only products that pass the design and hardcore enthusiasts standards that a true LCS chassis should be held to. The Tt LCS certification was created so that we at Thermaltake can designate to all power users which chassis’ have been tested to be compatible with extreme liquid cooling configurations to ensure you get the best performance from the best features and fitment.

Specifications:

Tube Dimensions supported: OD: 12mm , ID: 10mm

Kit Contents

2x Thermaltake Pacific G1/4 PETG Tube 90-Degree Dual Compression 12mm OD – Chrome 

6x Thermaltake Pacific M-Pro G1/4 PETG 12mm OD Compression – Chrome 

Caution:

Thermaltake recommends the following steps to be taken before using the Pacific series radiators and water blocks

To ensure a clean loop, flush and rinse your radiators and water blocks with distilled water prior to use.

Do not use tap water as your coolant, it may harm your loop and reduce performance.

Before storing your water cooling components, please clean, rinse and dry. This will ensure a longer lifespan for your components.

Thermaltake recommends the following steps to be taken after completing your water loop setup

Fill the reservoir with coolant and cycle the power on and off several times while the pump pushing the coolant into the loop.

DO NOT let the pump run dry, when there is no liquid entering the pump turn off your power immediately

Fill the reservoir to the top as it will prevent air from going into the pump

If necessary tilt the system slightly from side to side to bleed the air out of the loop.

Place some paper towels under fittings and joining points to test for leaks.

Run the loop with the fill port open for about 24 hours to completely bleed the air out of the loop

Before starting, flush out your system correctly to prevent any coolant or unwanted particles sticking to your tubes, radiators and other cooling components.

Coolant might fade over time.

Caution: The O-ring and the packing with a groove on the inside diameter must always be installed towards the top of the compression nut.

Please note: For use with Thermaltake PETG (12mm OD, 10mm ID) components only! 

This kit is to be used together with other water cooling components in order to have a functional cooling system. 

Product Link