Thermaltake Pacific 16mm OD 12mm ID PETG Fitting Kit – Starter is composed of one C1000 Opaque coolant white, four V-Tubler PETG tubes, ten Pacific G1/4 Chrome series fittings (6 x compression, 2 x 90° adapter, 2 x 90° compression) and other accessories. Together, these provide exceptional performance, unrivalled reliability, and styling for simple entry level custom loop.

C1000 Opaque Coolant White

Made in Germany, the non-flammable C1000 Opaque Coolant is a ready-to-use cooling solution with at least 3 years shelf life in airtight containers, providing great performance while preventing the entire cooling system – copper, brass, nickel, and aluminum – from corrosion.

V-Tubler PETG Tube 5/8” (16mm) OD 500mm (4 Pack)

Manufactured from premium PETG, the V-Tubler rigid tubing provides custom PC water cooling configurations with reliability and durability from end to end.

Pacific G1/4 PETG Tube 16mm (5/8”) OD Compression Fittings – Chrome

Six durable copper compression fittings allow proper connection to G1/4” ports to properly secure to cooling components.

Pacific G1/4 90 Degree Adapter – Chrome

Finished in chrome-plated copper, the adapter fitting is in 360° revolvable design, and consists of two sealed O-rings, allowing users to redirect the fittings at a 90 degree angle for easier tube routing.

Pacific G1/4 PETG Tube 90-Degree Compression 16mm OD – Chrome

Made in Taiwan, the 90° compression fitting is finished in chrome coatings, and enables connection of hard tube with G1/4" ports.

Specifications

Kit Contents

Cautions

Thermaltake recommends the following steps to be taken before using the Pacific series radiators and water blocks

• To ensure a clean loop, flush and rinse your radiators and water blocks with distilled water prior to use.
• Do not use tap water or distilled water as your coolant, it may harm your loop and reduce performance.
• It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while protecting the entire liquid loop from corrosion.
• Before storing your water cooling components, please clean, rinse and dry. This will ensure a longer lifespan for your components.

Thermaltake recommends the following steps to be taken after completing your water loop setup

• It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while preventing the entire cooling system – copper, brass, nickel, aluminum, and steel – from corrosion.
• Fill the reservoir with coolant and cycle the power on and off several times while the pump pushing the coolant into the loop.
• DO NOT let the pump run dry, when there is no liquid entering the pump turn off your power immediately
• Fill the reservoir to the top as it will prevent air from going into the pump
• If necessary tilt the system slightly from side to side to bleed the air out of the loop.
• Place some paper towels under fittings and joining points to test for leaks.
• Run the loop with the fill port open for about 24 hours to completely bleed the air out of the loop.

Please note: For use with Thermaltake PETG (16mm OD, 12mm ID) components only! 

This kit is to be used together with other water cooling components in order to have a functional cooling system. 

Manufacturer's link